Isn’t it great to be able to use your swimming pool throughout the year? With a pool inverter heat pump you can easily adjust the temperature of your pool and use it throughout the year. However, to keep your pool heat pump up and running, you will need to pay attention to its maintenance.
Even though there is not a lot of maintenance required for your pool heat pump. You can maintain it free of debris, such as leaves or pine needles, and check it occasionally for rodent nests or other wire-gnawing creatures.
Before we dive into inverter heat pumps maintenance, let’s see their major functions at a glance:
The main function of a pool heater is to pull out the cold water from the pool and bring it to a warm & comfortable temperature. They have a component called freon that facilitates the heating process. Pool heat pumps use a certain amount of electrical energy to complete the heating process. Pool inverter heat pumps pull the cold water and release the hot water and this process keeps going in circulation.
If you find your heat pumps not working, you can check for the following causes:
1. Power Supply:
Before you ring in the professional, try checking whether your inverter heat pump is getting an uninterrupted power supply. The power supply to your heat pump may get affected because of the simplest of reasons like loose wiring, bent wires, etc. Step one of maintaining your heat pumps is to ensure they get a proper power supply.
2. Ensure A Proper Water Flow:
A pool heat pump might not be able to function properly if the water level of your pool is insufficient. You can talk to your heat pump dealer or installer about the right water level for the heat pump to work and maintain that level to facilitate the proper functioning of your heat pump.
3. Clogged Parts:
To heat water, a heat pump needs air. The airflow will be insufficient to heat the water properly if the evaporator coil is clogged with debris. Check the coil and take out any debris that may have become lodged there, including any leaves, dirt, branches, twigs, or other objects.
4. Temperature Setting:
To keep your heat pool pump up and running for a long time, you must consider setting the right temperature. Is the temperature on the thermostat set correctly? Keep in mind that it must be adjusted higher than the water’s real temperature.
Check the water temperature with a thermometer to make sure your settings are accurate. If your pool inverter heat pump is not heating your pool water correctly, you might need to replace the thermostat.
5. Fix The Leaks:
Don’t freak out if you see water inside or around the heat pump. Your initial reaction might be that there’s a leak, but it might just be condensation building up inside the appliance and dripping later.
Check the water near the heat pump for chlorine using a test strip. If it displays a reading, you’ll know it’s a leak if the water is from a pool. You can unwind if the test strip returns no results because it’s just moisture. Still, it has to be fixed because it suggests that the heat pump most likely has a blocked drain.
These are the five simple steps that you can follow to ensure the right maintenance of your heat pump Sydney. Heat pumps function best outside with lots of space around the device and no impediments. They require a lot of air circulation. Make sure to place your heater carefully; on the flat ground close to a pool pump or filter, and make sure that airflow is controlled. The optimal placement for the heat pump, the required clearance, and where it should go in relation to your other equipment are all covered in-depth in your owner’s manual.
If you are looking for a great pool heat pump that’s efficient and high performing, you can rely on Madimack’s pool heat pump range for residential and commercial swimming pools. To know more about our heat pump Sydney, visit our website here: https://www.madimack.com.au/residential-pool-heat-pumps
